THEM Skates

Facet One Piece Soulplate for THEM Skates (908 + 909)

THEM Skates

Facet One Piece Soulplate for THEM Skates (908 + 909)

Pair of Facet Soulplate for THEM Skates, works perfect on both the 909 and older 908. Comes with 2x replacement UFS receivers for the toe.

Click here for details on colours we offer


£0.00
£60.00

QTY

You’ll earn 0 reward points with this purchase.

Go wild you can pick whatever colour combination that best suits your skates, your style (or your sports team). 

The original THEM square UFS receivers are a bad design, at the toe at least. The thick receiver results in thinner plastic, this combined with a very small surface area with sharp edges results in far too much stress on a small area of plastic. We have done a lot of testing and this was a potential failure point, we've also seen lots of reports and pictures of the original THEM soulplates failing at this point. There's no issues with the heel receiver as this is naturally stronger due to the heel raise. We've done away with this square receiver at the toe and provide every pair with new traditional round UFS receivers.

These soulplates use the original bridge hardware that comes with your skates but If you need new better quality (Torx) M4 soulplate fixing screws or you've lost yours you can find them in our hardware section.

Go wild you can pick whatever colour combination that best suits your skates, your style (or your sports team). 

The original THEM square UFS receivers are a bad design, at the toe at least. The thick receiver results in thinner plastic, this combined with a very small surface area with sharp edges results in far too much stress on a small area of plastic. We have done a lot of testing and this was a potential failure point, we've also seen lots of reports and pictures of the original THEM soulplates failing at this point. There's no issues with the heel receiver as this is naturally stronger due to the heel raise. We've done away with this square receiver at the toe and provide every pair with new traditional round UFS receivers.

These soulplates use the original bridge hardware that comes with your skates but If you need new better quality (Torx) M4 soulplate fixing screws or you've lost yours you can find them in our hardware section.

These soulplates are made using PLA-ST or PLA+ depending on the colour. 

Positive soul space 40mm - Negative souls space 32mm

Currently available in Small and Medium.

We will be making these soulplates in all sizes but it takes time, please be patient

Please be aware that ALL orders could take up to 4-6 weeks to be fulfilled depending on how busy our printers are. We are a small start up and have limited capacity. Every plastic part is printed on demand to your specifications just for you. To give you an idea, some parts can take up to a full 24 hours to print (i.e. ONE yeti one piece soulplate). If this wait is a problem, don't order.