Walls and H-Block Kit for 50/50 Prime Aluminium Core Frames

One of the best features of the Prime core frame is it's versatility allowing for a huge range of wheel set up options from large wheels to small, Hi-Lo, flat or rockered. The three standard set up options we provide is Max 65mm flat (FAST!), Max 60mm flat (large groove and versatile) and our favourite - 64/60mm Hi-Lo (Fast AND a large groove).

We spent a ton of time designing, testing and tweaking the groove to perfection. You now have the unique Cake Quad Groove. It's the perfect balance between minimal wheel bite and optimal boot down angle for riding flat and steezy easy royales. Don't be fooled, while huge wide grooves will help lock on but they do not help with wheel bite as they tend to be too deep resulting in wheels closer to the ledge or too large a groove radius so you don't get a solid lock in leading to slop and movement during slide. That's why we created the large wide radius main groove so it's impossible to miss and guides the grind edge into the centre of your frame. Additional smaller 45° and fastslide grooves in the centre of the main groove allow for positive solid lock on for long stable grinds, these grooves also acts as a pivot point for clean controlled switch ups. We've created maximum wheel bite protection wings possible without them getting in the way. Finally the edges are chamfered precisely to prevent the edges hanging up when carving hard but just enough left over to cess slide on the edge of the block instead of the wheels.

Our walls and H-Block are separate pieces in order to create much stronger printed parts, if they were printed as one piece they have weak layers leading to snapping at thin high stress areas particularly at the front and rear axle. This also allows for way more customisation, one of the core values here at Cake.

Is it obvious we obsess over the tech stuff? Well we obsess over the looks too, we think these are sweet AF.

FORM AND FUNCTION.